CAD CAM EDM DRO - Yahoo Group Archive

Re: oscilloscope for CNC

Posted by John Swenson
on 2003-06-30 14:04:31 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Harvey White <madyn@i...>
wrote:

> You already see that. You will see 100 mhz or better scopes, dual
> channel, delaying sweep (this is desirable... sorta lets you run a
> magnifier along the trace)... for 300 or less at hamfests,
> depending... Tektronix, not B&K or an off brand..
>

Last year a picked up a 150 MHz mini Tektronix dual trace, digital
storage scope with manual and two probes at a garrage sale for $75! It
was a bit of a gamble because I couldn't try it out in advance, but it
turns out towork great. With the storage features comes a whole raft
of trigger modes, without the manual it would have been really tough
to figure them all out. The storage aspect makes debugging digital
stuff much easier, you can see what happened before the trigger.

John S.

Discussion Thread

Stephan Kotzé 2003-06-29 01:25:50 UTC Subject: Re: oscilloscope for CNC Bernard R 2003-06-29 08:10:21 UTC Subject: Re: oscilloscope for CNC tanyasapa 2003-06-29 11:16:58 UTC Subject: Re: oscilloscope for CNC Lee Studley 2003-06-29 12:18:26 UTC bitscope Was: oscilloscope for CNC David A. Frantz 2003-06-29 16:43:35 UTC Re: [CAD_CAM_EDM_DRO] Subject: Re: oscilloscope for CNC turbulatordude 2003-06-29 18:15:07 UTC Subject: Re: oscilloscope for CNC turbulatordude 2003-06-29 18:15:19 UTC Subject: Re: oscilloscope for CNC turbulatordude 2003-06-29 18:15:39 UTC Subject: Re: oscilloscope for CNC Vince Negrete 2003-06-29 18:48:16 UTC Re: oscilloscope for CNC Charles Hixon 2003-06-29 18:54:25 UTC Subject: Re: oscilloscope for CNC Vince Negrete 2003-06-29 19:07:11 UTC Re: [CAD_CAM_EDM_DRO] Subject: Re: oscilloscope for CNC Harvey White 2003-06-29 19:19:19 UTC Re: [CAD_CAM_EDM_DRO] Re: oscilloscope for CNC Harvey White 2003-06-29 19:22:24 UTC Re: [CAD_CAM_EDM_DRO] Subject: Re: oscilloscope for CNC Charles Hixon 2003-06-29 19:39:25 UTC Subject: Re: oscilloscope for CNC turbulatordude 2003-06-30 03:31:46 UTC monitoring operation temperature ( was oscilloscope for CNC - Charles Hixon 2003-06-30 06:11:36 UTC Re: monitoring operation temperature ( was oscilloscope for CNC - John Swenson 2003-06-30 14:04:31 UTC Re: oscilloscope for CNC Harvey White 2003-06-30 14:14:21 UTC Re: [CAD_CAM_EDM_DRO] Re: oscilloscope for CNC Vic Shuttlewood 2003-06-30 15:41:32 UTC Re: [CAD_CAM_EDM_DRO] Re: monitoring operation temperature ( was oscilloscope for CNC -