CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection

on 2003-09-18 13:15:02 UTC
Hi KR,

You might try the circuit I posted in the files section, under
Driver/PS. The transformers, cap and bridge are cheap to buy.

For steppers, 180 oz/in would probably be fine:

http://www.mendonet.com/steppers/nema23.htm

And try TurboCNC for software!

Alan KM6VV
SherlineCNC list


khalique_rehman wrote:
>
> Hi Everyone,
> I am about to place an order for Taig CNC Ready Mill, 2019CR that I
> will convert to CNC (been in contact with Nick of CarterTools). I am
> inclined to buy Geckos 210. I intend to use Taig with whatever is
> Taig capable of. Most importantly jewelry, among other things.
> Given this information, how I choose the steppers and power supply.
> What would be their specs and the sources to buy from?
> Thanks.
> kr.
> No CNC experience but eager to learn (cost effectively).
>
> Addresses:

Discussion Thread

khalique_rehman 2003-09-18 12:15:18 UTC Taig Mill Conversion: Motor and Power Supply Selection Antonius J.M. Groothuizen 2003-09-18 12:21:28 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Statman Designs, LLC 2003-09-18 12:36:30 UTC Re: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection Tony Jeffree 2003-09-18 12:50:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:05:40 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:10:20 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Alan Marconett KM6VV 2003-09-18 13:15:02 UTC Re: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:23:07 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Tim Goldstein 2003-09-18 13:30:01 UTC RE: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection Alan Marconett KM6VV 2003-09-18 13:34:36 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig Mill Conversion: Motor and Power Supply Selection Tim Goldstein 2003-09-18 13:50:19 UTC RE: [CAD_CAM_EDM_DRO] Re: Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:58:07 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Fred Smith 2003-09-18 14:50:17 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection