CAD CAM EDM DRO - Yahoo Group Archive

Re: Taig Mill Conversion: Motor and Power Supply Selection

on 2003-09-18 13:23:07 UTC
Thanks Alan, I have saved the circuit and will look into it later.
By the way, can you suggest some sources for the components? I am
totally blank in this. And soon I will check the link you provided
for the steppers.
kr.

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Alan Marconett KM6VV
<KM6VV@a...> wrote:
> Hi KR,
>
> You might try the circuit I posted in the files section, under
> Driver/PS. The transformers, cap and bridge are cheap to buy.
>
> For steppers, 180 oz/in would probably be fine:
>
> http://www.mendonet.com/steppers/nema23.htm
>
> And try TurboCNC for software!
>
> Alan KM6VV
> SherlineCNC list
>
>
> khalique_rehman wrote:
> >
> > Hi Everyone,
> > I am about to place an order for Taig CNC Ready Mill, 2019CR
that I
> > will convert to CNC (been in contact with Nick of CarterTools).
I am
> > inclined to buy Geckos 210. I intend to use Taig with whatever is
> > Taig capable of. Most importantly jewelry, among other things.
> > Given this information, how I choose the steppers and power
supply.
> > What would be their specs and the sources to buy from?
> > Thanks.
> > kr.
> > No CNC experience but eager to learn (cost effectively).
> >
> > Addresses:

Discussion Thread

khalique_rehman 2003-09-18 12:15:18 UTC Taig Mill Conversion: Motor and Power Supply Selection Antonius J.M. Groothuizen 2003-09-18 12:21:28 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Statman Designs, LLC 2003-09-18 12:36:30 UTC Re: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection Tony Jeffree 2003-09-18 12:50:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:05:40 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:10:20 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Alan Marconett KM6VV 2003-09-18 13:15:02 UTC Re: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:23:07 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Tim Goldstein 2003-09-18 13:30:01 UTC RE: [CAD_CAM_EDM_DRO] Taig Mill Conversion: Motor and Power Supply Selection Alan Marconett KM6VV 2003-09-18 13:34:36 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig Mill Conversion: Motor and Power Supply Selection Tim Goldstein 2003-09-18 13:50:19 UTC RE: [CAD_CAM_EDM_DRO] Re: Taig Mill Conversion: Motor and Power Supply Selection khalique_rehman 2003-09-18 13:58:07 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection Fred Smith 2003-09-18 14:50:17 UTC Re: Taig Mill Conversion: Motor and Power Supply Selection