Re: [CAD_CAM_EDM_DRO] Re: age old question

Thanks Mariss.
I am adding new PMDC nema23 and nema34 servo motors to the product list on
my web page. It will be added in the next few days. The nema23 servo motors
with peak torque of 350 to 400 oz in (21 to 25 lb in) 4000-4700 RPM terminal
voltage of 60VDC.
The come w/o encoders but I can add the CPR you need.
The nema 34 motors range in peak torque from 480 oz in to 960 oz in (30 to
60 lb in), terminal voltage is 60VDC. The come with the rear shaft set up
for a .250 diameter bore code wheel. I can install the encoder cpr of your
choice.
See my web site at www.seanet.com/~dmauch and look in the product section.
Dan
Camtronics Inc

----- Original Message -----
From: "Mariss Freimanis" <mariss92705@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, February 03, 2005 6:15 PM
Subject: [CAD_CAM_EDM_DRO] Re: age old question


>
>
> Try Camtronics. Somehow Dan Mauch there has hooked into a good and
> continous supply of inexpensive new motors.
>
> Mariss
>
>
>