Xylotex Drives/TurboCNC Settings
Posted by
wanliker@a...
on 2006-05-22 22:05:34 UTC
I guess I am feeling dumb tonight...
How do you set the single Xylotex XS-3525/8S-1 drive for the various steps.
Full, Half, Quarter, and Eighth step.
I see four pins, two labeled MS-1, and two labeled MS-2. And I have two
jumpers available.
I think I understand how you would get the four different step positions.
However from the manual, I have not a clue to what jumper goes where. And I
do see the Truth Table in the lower corner of the manual, and it tells me
nothing as to positions of the jumpers????
A drawing would be the very best, showing positions with reference to the
main Step and Direction terminal strip.
Any help out there?
Also, in TurboCNC settings, are the Step and Direction settings supposed to
be Logic High or Logic low, when used with the Xylotex drive?
Thanks,
bill
[Non-text portions of this message have been removed]
How do you set the single Xylotex XS-3525/8S-1 drive for the various steps.
Full, Half, Quarter, and Eighth step.
I see four pins, two labeled MS-1, and two labeled MS-2. And I have two
jumpers available.
I think I understand how you would get the four different step positions.
However from the manual, I have not a clue to what jumper goes where. And I
do see the Truth Table in the lower corner of the manual, and it tells me
nothing as to positions of the jumpers????
A drawing would be the very best, showing positions with reference to the
main Step and Direction terminal strip.
Any help out there?
Also, in TurboCNC settings, are the Step and Direction settings supposed to
be Logic High or Logic low, when used with the Xylotex drive?
Thanks,
bill
[Non-text portions of this message have been removed]
Discussion Thread
wanliker@a...
2006-05-22 22:05:34 UTC
Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 22:28:04 UTC
Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:36:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:37:38 UTC
Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 22:49:56 UTC
Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:54:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings
Lester Caine
2006-05-22 22:54:35 UTC
Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:58:38 UTC
Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 22:59:03 UTC
Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 23:02:17 UTC
Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 23:15:04 UTC
Re: Xylotex Drives/TurboCNC Settings