CAD CAM EDM DRO - Yahoo Group Archive

Xylotex Drives/TurboCNC Settings

Posted by wanliker@a...
on 2006-05-22 22:58:38 UTC
In a message dated 5/22/2006 11:54:57 P.M. Mountain Daylight Time,
lester@... writes:

1 means NOT shorted to GND, so NO link :)



Unfortunately from everything on that board/manual, there is nothing to
indicate when something is shorted to ground?????
bill


[Non-text portions of this message have been removed]

Discussion Thread

wanliker@a... 2006-05-22 22:05:34 UTC Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 22:28:04 UTC Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:36:53 UTC Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:37:38 UTC Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 22:49:56 UTC Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:54:22 UTC Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings Lester Caine 2006-05-22 22:54:35 UTC Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:58:38 UTC Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 22:59:03 UTC Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 23:02:17 UTC Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 23:15:04 UTC Re: Xylotex Drives/TurboCNC Settings