Re: Xylotex Drives/TurboCNC Settings

Well,

I know how tough it can be to put together great manuals.

But I'd at least expect to have a description which ties it all
together.

I'm still not sure my assumption that an unbridged jumper pair is a
one. Cause the example board I had handy is older. Worst case,
you'll get 1/4 and 1/2 backwards. And full and 1/8 similarly
backwards. I always check anyways. Set mach to 3200 steps per unit,
and then you can use jog size or MDI to quickly determine if the
jumpers are right.

Ballendo

--- In CAD_CAM_EDM_DRO@yahoogroups.com, wanliker@... wrote:
>
>
> In a message dated 5/22/2006 11:28:35 P.M. Mountain Daylight
Time,
> ballendo@... writes:
>
> Now we can use the truth table to get the answers.
>
> (You're Right! this is MUCH harder than it needs to be!)
>
>
>
> Wouldn't it be wonderful if manuals had pictures?
> bill
>
>
> [Non-text portions of this message have been removed]
>