Re: Xylotex Drives/TurboCNC Settings
Posted by
ballendo
on 2006-05-22 22:59:03 UTC
Sorry,
Try this again. the single axis data sheet has a line which helps at
the bottom of page one:
http://www.xylotex.com/XS35V-1.pdf
It says, 1 is UNshorted to ground.
So yes, both jumpers off for 1/8 step.
With the xylotex.com printing on the single axis board facing you
in "correct reading" direction
The near pair is MS0,
the far pair is MS1
A single jmper on MS0 sets 1/4 step
A single jumper on MS1 sets 1/2 step
Both jumpers ON sets fullstep
And both OFF sets 1/8 step.
Hope THIS helps,
Ballendo
Try this again. the single axis data sheet has a line which helps at
the bottom of page one:
http://www.xylotex.com/XS35V-1.pdf
It says, 1 is UNshorted to ground.
So yes, both jumpers off for 1/8 step.
With the xylotex.com printing on the single axis board facing you
in "correct reading" direction
The near pair is MS0,
the far pair is MS1
A single jmper on MS0 sets 1/4 step
A single jumper on MS1 sets 1/2 step
Both jumpers ON sets fullstep
And both OFF sets 1/8 step.
Hope THIS helps,
Ballendo
>In CAD_CAM_EDM_DRO@yahoogroups.com, wanliker@... wrote:
>So what do I do for 1/8 step, leave all jumpers off? Remember I
>have the single board, not the triple drive board
> bill
Discussion Thread
wanliker@a...
2006-05-22 22:05:34 UTC
Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 22:28:04 UTC
Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:36:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:37:38 UTC
Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 22:49:56 UTC
Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:54:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings
Lester Caine
2006-05-22 22:54:35 UTC
Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 22:58:38 UTC
Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 22:59:03 UTC
Re: Xylotex Drives/TurboCNC Settings
wanliker@a...
2006-05-22 23:02:17 UTC
Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings
ballendo
2006-05-22 23:15:04 UTC
Re: Xylotex Drives/TurboCNC Settings