CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings

Posted by Lester Caine
on 2006-05-22 22:54:35 UTC
wanliker@... wrote:

> So what do I do for 1/8 step, leave all jumpers off? Remember I have the
> single board, not the triple drive board

http://www.xylotex.com/PDFS.htm

1 means NOT shorted to GND, so NO link :)

That would look right from the info and looking at the datasheet on the
chip ;)

--
Lester Caine - G8HFL
-----------------------------
L.S.Caine Electronic Services - http://home.lsces.co.uk
Model Engineers Digital Workshop -
http://home.lsces.co.uk/ModelEngineersDigitalWorkshop/
Treasurer - Firebird Foundation Inc. - http://www.firebirdsql.org/index.php

Discussion Thread

wanliker@a... 2006-05-22 22:05:34 UTC Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 22:28:04 UTC Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:36:53 UTC Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:37:38 UTC Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 22:49:56 UTC Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:54:22 UTC Re: [CAD_CAM_EDM_DRO] Re: Xylotex Drives/TurboCNC Settings Lester Caine 2006-05-22 22:54:35 UTC Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 22:58:38 UTC Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 22:59:03 UTC Re: Xylotex Drives/TurboCNC Settings wanliker@a... 2006-05-22 23:02:17 UTC Re: [CAD_CAM_EDM_DRO] Xylotex Drives/TurboCNC Settings ballendo 2006-05-22 23:15:04 UTC Re: Xylotex Drives/TurboCNC Settings