Xylotex Drives/TurboCNC Settings

In a message dated 5/22/2006 11:28:35 P.M. Mountain Daylight Time,
ballendo@... writes:

So if you have BOTH jumpers ON, you will be in Fullstep mode.
With the ONE jumper ON (MS2, nearest the EN pair), you're in 1/4
step.
With one jumper ON the farthest pair (MS1), you're in 1/2 step.

Hope this helps,




So what do I do for 1/8 step, leave all jumpers off? Remember I have the
single board, not the triple drive board
bill


[Non-text portions of this message have been removed]