Re: Stepper controller / driver for powerfeed

> > I would appreciate those too, thanks!
>
> If you join the Eleadscrew group,
>
> http://groups.yahoo.com/group/E-LeadScrew/
>
> You'll find the source code for the first Rev of the ELS proving the
> concept and allowing a wide range of step rates inside the interrupt
> routine along with acceleration code. It's for a PIC but should be easy
> enough to port to the atmega8. The only down side is then you're
> required to post the ported code as per GNU license.

Yes I have a pic programmer & compiler as well, I can use pic chips
but started using the AVR since it appeared to be more popular in
terms of samples and forums.

I will check this out.