Re: Stepper controller / driver for powerfeed

I have seen motor controllers that do exactly what you want, though I can't
remember where. Keep searching the web and you will find something
eventually. Your best bet is sites for electronics hobbyists. You're talking
about something that can be built with about $2 worth of parts. Try the
Jameco catalog.
--
Phil Mattison
http://www.ohmikron.com/
Motors::Drivers::Controllers::Software

----- Original Message -----
From: docstein99 <docstein99@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, September 29, 2007 5:05 AM
Subject: [CAD_CAM_EDM_DRO] Re: Stepper controller / driver for powerfeed


> Ok these options are too expensive and probably too complicated for
> what I want. This unit is for my little 9x20 cross-slide on my lathe.
> A speed dial, with forward/reverse switches - that sends a pulse to
> my stepper driver board will do the trick.
>
>