Re: [CAD_CAM_EDM_DRO] Source for used or surplus sealed keyboards?

In the mean time just take a piece of saran wrap and lay it over the
keyboard. Then secure in in place with a rubber band on each side. Every now
and then you need to tighten it back up but otherwise it is a cheap solution
while you look for a better cover.
Dan
-----Original Message-----
From: Jon Anderson <janders@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Friday, August 04, 2000 8:44 PM
Subject: [CAD_CAM_EDM_DRO] Source for used or surplus sealed keyboards?

>Have had some interesting moments when trying to stop my Ahha fitted
>knee mill, only to find a chip has worked it's way under the key,
>preventing a full stroke. I've checked a couple surplus catalogs I have,
>don't see any. I have seen keyboards that look normal, but are sealed to
>liquids and debris. I'd prefer one of these to a membrane, but would
>take a membrane over another chip under the escape key!
>Anyone have any ideas where I might find one, or have an extra laying
>around?
>
>Thanks,
>
>Jon
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>