Re: [CAD_CAM_EDM_DRO] Source for used or surplus sealed keyboards?

Jon,
If you are using the Artisan version, make a feed hold/cycle start pendant
by fitting two momentary push button switches in a box and connect it to the
ahha system with a three of four wire cable.
Much better than the ESC key as it doesn't stop the spindle.
Darrell

----- Original Message -----
From: "Jon Anderson" <janders@...>
To: "CAD_CAM_EDM_DRO@onelist.com" <CAD_CAM_EDM_DRO@egroups.com>
Sent: Friday, August 04, 2000 8:40 PM
Subject: [CAD_CAM_EDM_DRO] Source for used or surplus sealed keyboards?


> Have had some interesting moments when trying to stop my Ahha fitted
> knee mill, only to find a chip has worked it's way under the key,
> preventing a full stroke. I've checked a couple surplus catalogs I have,
> don't see any. I have seen keyboards that look normal, but are sealed to
> liquids and debris. I'd prefer one of these to a membrane, but would
> take a membrane over another chip under the escape key!
> Anyone have any ideas where I might find one, or have an extra laying
> around?
>
> Thanks,
>
> Jon
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>