Re: [CAD_CAM_EDM_DRO] Re: 3D Printing

On 12/18/2012 10:34 PM, Tony Smith wrote:

>
> I thought this: http://dx.com/p/digital-temperature-controller-66334 was
> cheap. Well it is, but anyway. BTW those are quite good, they'll do heat &
> cool (eg oven & fridge control) while most only do heating. They're also
> 76x76mm, not 48x48mm unfortunately.
>
> Tony

I have one of these from an ebay seller. Mine came with the
thermocouple, but not all do. There is an error in the specs. It states
400C max, but when you reprogram for the type K thermocouple it will go
much higher. IIRC, it will go to the limits of the type K thermocouple.
One other issue, I could not change mine to read out in F. Not a huge
deal, but less convenient for those in the US.

--


Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA

Think, Draw, Print. 3D printers ROCK!

http://www.plansandprojects.com/My%20Machines/PrusaMendel2012-1/

http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/

Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/