Re: [CAD_CAM_EDM_DRO] virtual hand jive

That shouldn't be to hard for the software people Joe...I've got an old
program around here somewhereI never use anymore that has something very
similar to that.

Smoke
-----Original Message-----
From: Joe Vicars <jvicars@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Monday, November 06, 2000 2:14 PM
Subject: Re: [CAD_CAM_EDM_DRO] virtual hand jive

> I would love to see someone come up with the virtual handwheel.
>A couple of interesting points:
> 1. DanCad supports joystick input.
> 2. Here is a link for a CNC retofit for Boss controllers. It shows

pictures of a "pendant" that looks like what most of us (I

>think) have in mind.
>
> http://www.centroidcnc.com/m39.html
>
>
>
>Anne Ogborn wrote:
>
>> ON a slight, but only slight, side note,
>>
>> I build model railroads, and we're constantly needing "turn
>> this shaft here and make that turn over there".
>>
>> One solution I've used is to wire two permag motors in parallel
>> (no power supply). When one motor turns, the other turns more or
>> less with it. If you put a spur gear based reduction on each one
>> you'll find they more or less stay in synch, at least well enough
>> for a manual control.
>>
>> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>>
>> Addresses:
>> Post message: CAD_CAM_EDM_DRO@egroups.com
>> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>> Moderator: jmelson@... [Moderator]
>> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>> FAQ: http://www.ktmarketing.com/faq.html
>> bill,
>> List Manager
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>