Re: [CAD_CAM_EDM_DRO] Re: Looking for short ballscrew

There is an "easy" solution...but it's not cheap. It requires redesign and
replacement of the inner driveshaft for the spindle for starters. I could
do it, but don't have time as I'm too involved with my other project at the
moment.

Smoke
-----Original Message-----
From: dave engvall <dengvall@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Sunday, December 03, 2000 11:37 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Looking for short ballscrew

>Jon Anderson wrote:
>
>> Greg Nuspel wrote:
>>
>> > I see your point. Wouldn't it be nice if there was an easy/cheap way
>>
>
>In short form:
>
> GOOD
> CHEAP
> FAST
>
> Pick any two!
>
>...........................................................................

............................................................................
...

>
>I once made a very nice gear out of A2 to drive my quill. Good fit but

not perfect...still about 0.003" backlash when fit up very

>tightly. It bypassed all the gearing and was hard to drive. Still don't

have an ideal solution.

>
>Dave
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>