Re: [CAD_CAM_EDM_DRO] Re: 7 square holes --was,lost post

The angle you need to regrind the point to depends on what angle the head is
tilted to. I'd have to sit down and draw this out and calculate the angles.
At the same time I did this I'd be able to check for clearance between the
tool head and the work.

Smoke

>What angle? What if I rotated the part to position 1, cut the
>corner, rotated the part to position 2 and cut the corner again?
>Wht are the positions?
>
>Best Regards,
>
>Fred Smith
>IMService
>