Re: [CAD_CAM_EDM_DRO] Re: 7 square holes --was,lost post

Fred, Once you tip the part (or the spindle) to an angle other than 90
degrees between the part and the tool, you'd still need to alter the 45
degree tool tip to something other than 45 degrees.

Smoke
-----Original Message-----
From: Fred Smith <imserv@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Wednesday, December 13, 2000 1:13 PM
Subject: [CAD_CAM_EDM_DRO] Re: 7 square holes --was,lost post

>>Message: 2
>> Date: Wed, 13 Dec 2000 00:51:30 -0800
>> From: Brian Pitt <bfp@...>
>>Subject: Re: 7 square holes --was,lost post
>>
>>yes I'm talking sharp cornered trully square holes
>>or pockets with sharp corners
>
>How about tilt a 45 degree v-tipped cutter at an angle & draw it vertically

up & down along the corner.

>You can tilt the part & use a 3D CNC move too with a vertical tool along

the corner too. Easy to do multiple corners with a rotary table or
indexer(super spacer style).

>
>
>
>Best Regards, Fred Smith- IMService
>Listserve Special discounts and offers are at:

http://209.69.202.197/cadcamedmdro.html

>
>imserv@... Voice:248-486-3600 or 800-386-1670 Fax: 248-486-3698
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>