Re: [CAD_CAM_EDM_DRO] Re: Scanner/Digitizer

Would this digitizer work if installed on a standard CNC mill with 3 or four
axis?

Smoke
-----Original Message-----
From: John D. Guenther <jguenther@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, January 02, 2001 2:42 PM
Subject: [CAD_CAM_EDM_DRO] Re: Scanner/Digitizer

>Alan,
>
>You can order back issues from Strictly IC, the url is
>www.strictlyic.com. You will have to call them, all necessary
>information on the web site. No, I am not building it, but I might
>sometime down the road.
>
>John Guenther
>
>
>--- In CAD_CAM_EDM_DRO@egroups.com, Alan Marconett KM6VV <KM6VV@a...>
>wrote:
>> John,
>>
>> Do you think we can order reprints of the articles? Do you have a
>URL
>> for the magazine, and are you building it?
>>
>> Alan KM6VV
>>
>> "John D. Guenther" wrote:
>> >
>> > Tom,
>> >
>> > Strictly IC magazine just published a two part article on this
>subject
>> > complete with drawings for the digitizer frame. This was in the
>> > October/November and December/ January 2000/2001 issues. This is a
>> > large, 6 foot by 8 foot, digitizer which uses the MaxNC software
>and
>> > the MaxNC digitizing probe. Of course this could be scaled up or
>down
>> > depending on your needs. The guy who designed it is digitizing a
>> > complete Model T Ford engine to reproduce it in miniature. The
>> > project was rather simple, just large, an looks like it would work
>> > rather well for large items.
>> >
>> > John Guenther
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>