Re: Scanner/Digitizer

John,

Thanks, I took a look at the site. Both articles are in 2000 (vol 13)?
Too bad I don't build I.C. engines, sounds like a good mag. Actually, I
doubt if I will build a digitizer THAT big, but I still want to take a
look at the article. Did they mention prices for digitizer head or
software?

Alan KM6VV


"John D. Guenther" wrote:

>
> Alan,
>
> You can order back issues from Strictly IC, the url is
> www.strictlyic.com. You will have to call them, all necessary
> information on the web site. No, I am not building it, but I might
> sometime down the road.
>
> John Guenther
>
> --- In CAD_CAM_EDM_DRO@egroups.com, Alan Marconett KM6VV <KM6VV@a...>
> wrote:
> > John,
> >
> > Do you think we can order reprints of the articles? Do you have a
> URL
> > for the magazine, and are you building it?
> >
> > Alan KM6VV
> >
> > "John D. Guenther" wrote:
> > >
> > > Tom,
> > >
> > > Strictly IC magazine just published a two part article on this
> subject
> > > complete with drawings for the digitizer frame. This was in the
> > > October/November and December/ January 2000/2001 issues. This is a
> > > large, 6 foot by 8 foot, digitizer which uses the MaxNC software
> and
> > > the MaxNC digitizing probe. Of course this could be scaled up or
> down
> > > depending on your needs. The guy who designed it is digitizing a
> > > complete Model T Ford engine to reproduce it in miniature. The
> > > project was rather simple, just large, an looks like it would work
> > > rather well for large items.
> > >
> > > John Guenther
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager