Re: Scanner/Digitizer

Ballendo,

OK, a 3/8 straight shank would be fine. Even a bigger one could be
accommodated, with the correct end mill holder. Provided it is not too
long.

Alan KM6VV


ballendo@... wrote:

>
> Alan wrote:
> >Did you find the spindle size? Morse 1?? I was going to
> >check the MaxNC site, haven't done that yet.
>
> Alan,
>
> It appears from the picture to be a straight shank, I'd guess 3/8 to
> 1/2 inch diameter. Fits with the verbiage below the pic, i.e. using a
> collet to hold it.
>
> Ballendo