CAD CAM EDM DRO - Yahoo Group Archive

Re: Scanner/Digitizer

on 2001-01-03 11:09:29 UTC
Tony,

Interesting. Did you find the spindle size? Morse 1?? I was going to
check the MaxNC site, haven't done that yet. Was up to 3:00 am last
night, helping my son Andre' finish up his initiation project (a Bent,
for Tao Beta Pi)! but he's back to UC Davis today, after a stop off at
the company I work for. He interned here two summers, and is looking
for a reference letter for grad school.

Alan KM6VV

Tony Jeffree wrote:
>
> At 07:24 03/01/01 +0000, you wrote:
> >See http://www.positiveflow.com/maxacc.htm, Dearmond Tool. Digitizer
> >fits into MaxNC spindle. Don't know size... yet.
>
> Interesting...confirms what I had previously suspected, that the MaxNC
> spindle/collets are actually manufactured by Taig. So the digitizer will
> fit Taig mills also.
>
> Regards,
> Tony

Discussion Thread

Tom 2001-01-02 12:08:47 UTC Scanner/Digitizer John D. Guenther 2001-01-02 12:26:03 UTC Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-02 12:28:15 UTC Re: [CAD_CAM_EDM_DRO] Scanner/Digitizer Alan Marconett KM6VV 2001-01-02 12:30:40 UTC Re: Scanner/Digitizer John D. Guenther 2001-01-02 12:48:58 UTC Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-02 13:23:39 UTC Re: Scanner/Digitizer Tom Csibor 2001-01-02 13:55:05 UTC Re: Scanner/Digitizer Smoke 2001-01-02 13:59:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-02 14:34:01 UTC Re: Scanner/Digitizer Tom Csibor 2001-01-02 15:34:53 UTC Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-02 15:59:32 UTC Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-02 23:24:10 UTC Re: Scanner/Digitizer Tony Jeffree 2001-01-03 00:23:38 UTC Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-03 11:09:29 UTC Re: Scanner/Digitizer Tony Jeffree 2001-01-03 14:30:41 UTC Re: Scanner/Digitizer ballendo@y... 2001-01-03 19:22:25 UTC Re: Scanner/Digitizer ballendo@y... 2001-01-03 19:34:03 UTC Re: Scanner/Digitizer Alan Marconett KM6VV 2001-01-03 20:18:29 UTC Re: Scanner/Digitizer Smoke 2001-01-03 20:55:57 UTC Re: [CAD_CAM_EDM_DRO] Re: Scanner/Digitizer