CAD CAM EDM DRO - Yahoo Group Archive

Using wood router on aluminum

Posted by Vic Fraenckel
on 2001-05-15 11:55:16 UTC
Is it possible to mill openings in aluminum panels using a wood router? If
so, are there cutters available to use with the router?

Any advice or comments appreciated.

Vic
________________________________________________________

Victor Fraenckel - The Windman vfraenc1@...
KC2GUI www.windsway.com

Home of the WindReader Electronic Theodolite
Read the WIND

Discussion Thread

Vic Fraenckel 2001-05-15 11:55:16 UTC Using wood router on aluminum cadman@p... 2001-05-15 12:06:26 UTC Re: Using wood router on aluminum Joe Vicars 2001-05-15 12:18:44 UTC Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum Bob Campbell 2001-05-15 13:04:04 UTC Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum jguenther@l... 2001-05-15 13:17:03 UTC Re: Using wood router on aluminum Bob Campbell 2001-05-15 13:48:49 UTC Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum JanRwl@A... 2001-05-15 15:11:33 UTC Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum JanRwl@A... 2001-05-15 15:19:10 UTC Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum Bob Campbell 2001-05-15 17:39:57 UTC Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum ballendo@y... 2001-05-15 19:28:12 UTC Re: Using wood router on aluminum ballendo@y... 2001-05-15 19:38:17 UTC Re: Using wood router on aluminum ballendo@y... 2001-05-15 20:22:06 UTC Re: Using wood router on aluminum yahoo@a... 2001-05-16 05:18:32 UTC Re: Using wood router on aluminum rab@r... 2001-05-16 08:00:56 UTC Re: Using wood router on aluminum ballendo@y... 2001-05-21 17:21:07 UTC Re: Using wood router on aluminum