Re: Using wood router on aluminum
Posted by
ballendo@y...
on 2001-05-15 20:22:06 UTC
Bob,
While I agree with the tone and nature of your post, there's one word
to be careful of: USUALLY
It only takes once...
Hope this helps.
Ballendo
P.S. There's a reason the European safety standards require
enclosures around cnc equipment!
While I agree with the tone and nature of your post, there's one word
to be careful of: USUALLY
>Router bits bit when they break USUALLY don't go supersonic. TheyYes, they USUALLY do, but SOMETIMES they DON'T just "lie down"!!!
>USUALLY just fall where they are.
It only takes once...
Hope this helps.
Ballendo
P.S. There's a reason the European safety standards require
enclosures around cnc equipment!
--- In CAD_CAM_EDM_DRO@y..., "Bob Campbell" <bob@c...> wrote:
> JRR,
>
> I need to take exception with some of what you have said. A
properly
> designed cnc router is designed to cut aluminum and other soft
metals. You
> should always wear eye protection when working around any cnc
machine. When
> cutting aluminum, don't try and make large cuts. When I am
pocketing, I
> only go down 1/10 of an an inch at a time. I run my machine at 10
to 15
> inches per minute.
>
> Router bits bit when they break usually don't go supersonic. They
usually
> just fall where they are.
>
> Bob Campbell
<big snip of previous posts>
Discussion Thread
Vic Fraenckel
2001-05-15 11:55:16 UTC
Using wood router on aluminum
cadman@p...
2001-05-15 12:06:26 UTC
Re: Using wood router on aluminum
Joe Vicars
2001-05-15 12:18:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum
Bob Campbell
2001-05-15 13:04:04 UTC
Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum
jguenther@l...
2001-05-15 13:17:03 UTC
Re: Using wood router on aluminum
Bob Campbell
2001-05-15 13:48:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum
JanRwl@A...
2001-05-15 15:11:33 UTC
Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum
JanRwl@A...
2001-05-15 15:19:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum
Bob Campbell
2001-05-15 17:39:57 UTC
Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum
ballendo@y...
2001-05-15 19:28:12 UTC
Re: Using wood router on aluminum
ballendo@y...
2001-05-15 19:38:17 UTC
Re: Using wood router on aluminum
ballendo@y...
2001-05-15 20:22:06 UTC
Re: Using wood router on aluminum
yahoo@a...
2001-05-16 05:18:32 UTC
Re: Using wood router on aluminum
rab@r...
2001-05-16 08:00:56 UTC
Re: Using wood router on aluminum
ballendo@y...
2001-05-21 17:21:07 UTC
Re: Using wood router on aluminum