Re: Using wood router on aluminum
Posted by
cadman@p...
on 2001-05-15 12:06:26 UTC
I would think that the RPM would be too high to go aginst
aluminum, even for Carbide. I have cut aluminum plate 1/2" thick with
my table saw and a carbide blade with no problems. If you got a
router speed control to slow down the RPM and used a carbide bit you
could do it.
CADMAN
aluminum, even for Carbide. I have cut aluminum plate 1/2" thick with
my table saw and a carbide blade with no problems. If you got a
router speed control to slow down the RPM and used a carbide bit you
could do it.
CADMAN
--- In CAD_CAM_EDM_DRO@y..., "Vic Fraenckel" <vfraenc1@n...> wrote:
> Is it possible to mill openings in aluminum panels using a wood
router? If
> so, are there cutters available to use with the router?
>
> Any advice or comments appreciated.
>
> Vic
> ________________________________________________________
>
> Victor Fraenckel - The Windman vfraenc1@n...
> KC2GUI
www.windsway.com
>
> Home of the WindReader Electronic Theodolite
> Read the WIND
Discussion Thread
Vic Fraenckel
2001-05-15 11:55:16 UTC
Using wood router on aluminum
cadman@p...
2001-05-15 12:06:26 UTC
Re: Using wood router on aluminum
Joe Vicars
2001-05-15 12:18:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum
Bob Campbell
2001-05-15 13:04:04 UTC
Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum
jguenther@l...
2001-05-15 13:17:03 UTC
Re: Using wood router on aluminum
Bob Campbell
2001-05-15 13:48:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum
JanRwl@A...
2001-05-15 15:11:33 UTC
Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum
JanRwl@A...
2001-05-15 15:19:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using wood router on aluminum
Bob Campbell
2001-05-15 17:39:57 UTC
Re: [CAD_CAM_EDM_DRO] Using wood router on aluminum
ballendo@y...
2001-05-15 19:28:12 UTC
Re: Using wood router on aluminum
ballendo@y...
2001-05-15 19:38:17 UTC
Re: Using wood router on aluminum
ballendo@y...
2001-05-15 20:22:06 UTC
Re: Using wood router on aluminum
yahoo@a...
2001-05-16 05:18:32 UTC
Re: Using wood router on aluminum
rab@r...
2001-05-16 08:00:56 UTC
Re: Using wood router on aluminum
ballendo@y...
2001-05-21 17:21:07 UTC
Re: Using wood router on aluminum