Re: [CAD_CAM_EDM_DRO] Request help from group

That's pretty easy...let me make a sketch and send it to you.

Smoke

-----Original Message-----
From: STAN MCDONALD <SMCDONAL@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com <CAD_CAM_EDM_DRO@yahoogroups.com>
Date: Sunday, July 22, 2001 7:45 PM
Subject: [CAD_CAM_EDM_DRO] Request help from group

>Hello list I am working on a project and need to request your assistance. I
>am atempting to make a rotary turning table to be driven by an air cylinder
>and I need to have the cylinder be retracted and then when fully extended
>have the table have moved min 200 degrees or more. The problem I have run
>into is when the cylinder has moved the table 180 degrees ( how do we
>position the cylinder so that we would not need to stop remove the cylinder
>and then retract the cylinder with it on the other side of center?
>
>The table is a 1-1/2" thick plate cut round 14-15" in dia made of steel. I
>have an arm stuck out one side to connect whatever to and the whole thing

is

>resting on some bearings for movment (similar to a car front axel).
>
>Thanks
>
>Stan
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>