cnc tapping Re: General Tool Life Question

>In a message dated 1/18/2002 3:42:02 PM Mountain Standard Time,
>machines@... writes:
>
>
>> If I get banned for this OK you make the rules but you or Tim need

to

>> explain why it's OT and I don't feel that a "because I say so" is
>> sufficient.
>> Perhaps the aims of the group need rewriting?
>>
>> John S.
>>
>>
>
>If you had read my answers and learned you would know my thoughts.

And no, I

>am not going to change the subjects of the group for your or anyone

elses

>benefit.
>If you continue to argue onlist you will be banned.
>bill

Sorry I still think it's in the lists interests
The subject heading is CNC tapping.
Also the post from Chris Straton I think sums it up in that you
either haven't been following it or don't under stand it.
There are laid down tapping cycles for CNC machines. This is in the
groups charter.
The previous post to mine from Fred explained clearly HOW it could be
achieved on a CNC. In the past 3/4 of an hour or so I have had one on
group and 4 off group enquiries for a sketch.
That's how much on topic the list members think it is.

John S.