CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re:Walk Thru Programing

on 2002-02-01 19:02:45 UTC
Ron:

Acurite or your system sounds like it fits a class of problems where a part
is available, but no drawing. Can either of these programs take the "output"
from your walkthrough and generate either a DXF or G-Code so that a drawing
can be generated?

-- Jerry

|-----Original Message-----
|From: ron [mailto:ron]On Behalf Of ron ginger
|Sent: Friday, February 01, 2002 7:53 PM
|To: CAD_CAM_EDM_DRO@yahoogroups.com
|Subject: [CAD_CAM_EDM_DRO] Re:Walk Thru Programing
|
|
|This is one of the major reasons I like the Acurite MillPower control.
|It makes this kind of project real easy. You place your part on the mill
|table, then select the first feature you want to do- say a drilled hole.
|The popup box asks for the hole location, and you press the jog buttons
|until you have the spindle over the hole- use a centerfinder if needed.
|

Discussion Thread

dcsaws 2002-02-01 15:37:12 UTC Walk Thru Programing stevenson_engineers 2002-02-01 15:53:07 UTC Re: Walk Thru Programing ballendo 2002-02-01 15:54:42 UTC Teach-in was Re: Walk Thru Programing Alan Marconett KM6VV 2002-02-01 16:40:04 UTC Walk Thru Programing Chris L 2002-02-01 16:52:17 UTC Re: [CAD_CAM_EDM_DRO] Teach-in was Re: Walk Thru Programing Carol & Jerry Jankura 2002-02-01 17:16:21 UTC RE: [CAD_CAM_EDM_DRO] Re: Walk Thru Programing ron ginger 2002-02-01 18:35:46 UTC Re:Walk Thru Programing Carol & Jerry Jankura 2002-02-01 19:02:45 UTC RE: [CAD_CAM_EDM_DRO] Re:Walk Thru Programing ballendo 2002-02-01 19:32:21 UTC Re:Walk Thru Programing vrsculptor 2002-02-01 19:46:14 UTC Re: Walk Thru Programing ron ginger 2002-02-01 20:00:30 UTC Re:Walk Thru Programing Marcus & Eva 2002-02-02 08:03:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Walk Thru Programing