Re: EMC Contouring Settings/ downloading BDI

Hi Art,

Thanks for the reply. I had what I thought was a similar problem, in
that the 'A' axis in a combined move didn't dictate the move. I figured
out that the actual steps (steps, not inches and degrees) needed by the
'A' axis was less then the 'X' axis, which is, after I read it again,
not true of your test case.

Alan KM6VV

Art Fenerty wrote:

>
> Hi Alan:
>
> No, its just that the Tajectory planner, no matter what the steps, only
> cycles the XYZ axis. It always assumes the A will move by itself. Thats why
> the X move in the example would have to have the feedrate adjusted way down.
> I believe its just a bug in the design. All axis should be cycled in the
> planner.
> Art
> Master5 Software
> http://users.andara.com/~fenerty/master.htm