Re: [CAD_CAM_EDM_DRO] New Pix UP!

Alan! Excellent workmanship and layout-engineering, but, opto-isolator
inputs to the Gecko drives notwithstanding, it gives me the heebie-jeebies to
have the input-lines nearly in the same harness as the motor-winding wires!
I will be mounting TWO G210's inside an application-specific plotter I am
cobbling, and I envision running the motor-wires "at right angles" to the
input-wiring, where they must cross, at least for an inch or so before "going
parallel" to them. Is this "overkill"? or "electrical paranoia"???

Wow, you did the harnessing nicely without Tye-Wraps! I'd have used a good
100 of 'em in that! Or, braided nylon cable-thread?

Appreciate you putting these photos here for all to see! This is what it's
all about!

Jan Rowland