Re: [CAD_CAM_EDM_DRO] EMC and no response from M3

Paul wrote:

> Hi Jon
>
> Yes, the spindle will not be turned on untill a speed is commanded. If you
> think about it, why turn it on if the speed is at zero (the default setting).
>
> As far as sending an output via a DAC, the code has never been there as far
> as I'm aware. Although it shouldn't be too difficult to add it once you have
> decided on which DAC to use.

Pieces of the code ARE there, some of it even commented. I tried tracing
through it once, but got lost. There are some comments in the STG driver,
I think, about sending spindle speed to the last DAC channel, if it is not
used by an axis.

Thanks,

Jon