Re: [CAD_CAM_EDM_DRO] Emc

Gene wrote:

> How would you change directions on the axis? On the Z axis the minus
> side is going down which seems to work fine. On the X axis the minus
> side is moving to the right. On the Y axis the minus side is moving away
> (in). The thing writes backwards. Im using gekkos and EMC.

If this is a machine with a fixed tool and a moving workpiece, then
it sounds like X is backwards. Reverse any one stepper phase coil
(on a Gecko, swap wires A and B) and the movement will be reversed.

-X moves should move the work to the right, so the tool is positioned
more to the left on the workpiece. -Y moves should move the table away,
so the tool is closer toward the operator on the workpiece. -Z should
have to tool approach the top of the workpiece.

Jon