Re: [CAD_CAM_EDM_DRO] Re: Emc

on 2002-08-08 16:21:52 UTC

How would I bring up a terminal in that directory and what command would
i use to start EMC?

Ray Henry wrote:

>
> Gene
>
> I'd say that you are getting a bad line of code in there about where it
> stops. The problem is that the EMC you are running doesn't always
> display the current error messge so you don't see what is happening.
>
> If you change the debug line in your ini file from
>
> DEBUG = 0x00000003
>
> to
>
> DEBUG = 0x7FFFFFFF
>
> and then start the emc using a terminal in the /usr/local/emc directory
> you will see the motion command messages printed in the terminal window
> and can figure out about which line is causing problems.
>
> My bet's on a g0, g1, or g2 on a line with no x, y, or z position.
>
> HTH
>
> Ray
>
> > Date: Thu, 08 Aug 2002 07:54:53 -1000
> > From: Gene <capper@...>
> > Subject: Emc
> >
> > Has anyone had any problems running vector files on EMC and geckos? I
> > can make the files and it starts running good and then stops after a
> > while on what appears top be good code. After it stops there is nothing
> > I can do to start again. If I push run again it goes back to start
> > again and stops in the same place. Bobcad files wont run at all. Desk
> > engrave files run good.
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread