Re: Re: EMC steps/rev calibration

nahydro

Now I think we may be getting somewhere. Divide 1.25 by 5 and you get the
conversion factor from metric to inch. Try issuing a g20 before the x5 and
see what happens. If that fixes it you might want to compare emc.ini with
generic.ini and add the command to the interpreter that is in generic.

Ray

>    From: "nahydro" <r_fl_z@...>
> Subject: Re: EMC steps/rev calibration
>
>
> Alan:
>
> Thanks for trying.  I wish it was as simple as mis reading the jumper
> setting.  I've tried all four positions, and am convinced I have that
> part right.  
>
> I am now running the G340 at 1x, 500 cpr encoder, and 5 tpi
> screw...which should make INPUT_SCALE 500*5 or 2500. I am using
> steppermod.  A one inch jog results in the motor turning about 1.25
> revs instead of 5.