Re: EMC steps/rev calibration

Hi Nahydro,

Is that your name? Just another thought for you. When encoders are
used, I believe one gets 4X the cpr of the encoder. And I notice your
steps are off by 4:1. SO... possibly this is the source of the error.

HTH

Alan KM6VV

nahydro wrote:

>
> Alan:
>
> Thanks for trying. I wish it was as simple as mis reading the jumper
> setting. I've tried all four positions, and am convinced I have that
> part right.
>
> I am now running the G340 at 1x, 500 cpr encoder, and 5 tpi
> screw...which should make INPUT_SCALE 500*5 or 2500. I am using
> steppermod. A one inch jog results in the motor turning about 1.25
> revs instead of 5.
>
> I've pasted the relavent emc.ini for the first axes below for
> reference. If something is wrong with it, I can't see it. Is it time
> for DOS?
>
> TIA