Re: [CAD_CAM_EDM_DRO] Beginners screws ( was ACME ( was Re: leadscrew,

OK,
just uploaded the file of DIY linear guide.
It is done for somebody with limited machining capabilities, but with
burning desire to learn CNC, like myself.
Alex

----- Original Message -----
From: CL <datac@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, May 19, 2003 10:47 PM
Subject: Re: [CAD_CAM_EDM_DRO] Beginners screws ( was ACME ( was Re:
leadscrew,


>
>
> alex wrote:
>
> >Thank you, Ross - I'm more or less sure now what to do.
> >Will place sprocket directly on the shaft of stepper, then pull carriage
in
> >a loop by the chain.
> >
> You might want to slide that sprocket in a little further so you can at
> least get a smidget of support on the end of that motor shaft with an
> outbound bearing....
>
> It still is not enough, but that would be better than nothing.
> Most steppers are not made to take much of any side load on their
bearings.
>
> Ultimately, you need to put the sprocket between two bearings on a shaft
> that is driven direct by the stepper with a Helical coupler.
> Or, mount the motor to a short section of square aluminum tubing with a
> bearing on each side. One bearing can be right on the motor shaft, the
> other on an extension with the Sprocket.
>
> That obviously takes more work.
>
> Then again, if motors are cheap enough, just replace the motor when it
> goes "south".
>
> Chris L
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>