Re: Tapered Threads? Kim's TurboCNC codes

The G Codes you have programmed would be a great addition to
TurboCNC, I hope you and Dave can come to an agreement on these.

You point on true open source is valid, but it supprises me that the
EMC community still haven't added slaving an axis to an uncontrolled
encoder count (lathe threading).

Thanks for pointing out that the encoder signal may not be
symetrical. Really I have no reason to change the code to sync twice
per rev, I just thought it might be a good first project to learn the
code. Multiple encoder counts would add resolution to single pass
threads, but would then need a one/rev index count to allow multiple
passes along the same thread.

Mark