CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko 210s l- limited rapids

Posted by skykotech
on 2004-08-20 20:02:26 UTC
> It looks like there is a #10 terminal that is supposed to be
> connected to the common 5vdc power supply but it is not connected.
> I wonder if that could be part of the problem?

Uhm, yeah, you should be connecting terminal #10 to the common
(ground) of the system generating your pulses. I assume you are
using a parallel port, in which case I think the ground pins are 18-
25 (double check me on that). I am quite surprised you are getting
controlled movement at all with terminal #10 disconnected...that is
the cathode of the leds in the opto-isolators in the gecko drive.
Actually, I wonder if there is an error in the Gecko manual...it says
to connect terminal 10 to either supply or ground...but a drawing
later on shows terminal 10 connected to the cathode of the leds,
meaning it should be ground only. Perhaps Marris uses bidirectional
opto leds and just doesn't show it in the doc???


Rick

Discussion Thread

theokspindoctor 2004-08-20 18:41:13 UTC Gecko 210s l- limited rapids Steven Ciciora 2004-08-20 18:53:41 UTC Re: [CAD_CAM_EDM_DRO] Gecko 210s l- limited rapids Torsten 2004-08-20 19:09:34 UTC Re: Gecko 210s l- limited rapids Keith Clark 2004-08-20 19:29:30 UTC Re: Gecko 210s l- limited rapids Keith Clark 2004-08-20 19:41:30 UTC Re: Gecko 210s l- limited rapids skykotech 2004-08-20 20:02:26 UTC Re: Gecko 210s l- limited rapids Ron K 2004-08-20 20:14:08 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210s l- limited rapids Jon Elson 2004-08-20 21:33:11 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210s l- limited rapids Keith Clark 2004-08-20 22:29:53 UTC Re: Gecko 210s l- limited rapids Jon Elson 2004-08-21 12:05:11 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210s l- limited rapids Keith Clark 2004-08-21 12:36:19 UTC Re: Gecko 210s l- limited rapids Keith Clark 2004-08-21 13:15:17 UTC Re: Gecko 210s l- limited rapids Jon Elson 2004-08-21 21:42:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210s l- limited rapids Jon Elson 2004-08-21 21:50:33 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210s l- limited rapids Keith Clark 2004-08-22 15:12:24 UTC Re: Gecko 210s l- limited rapids Jon Elson 2004-08-22 22:48:04 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210s l- limited rapids