Re: Bridgeport retrofit servo questions

Yes...probably about $60/ea...but you'll be getting exactly the
encoder you need & not fussing about with turning shafts down,
drilling holes or compromising on encoder counts.

I'm not sure if Renco has a cheaper/comparable model that will work.
I only started investigating encoders last night...more on these
later. I'll keep you posted.

-Brady

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Luke1027 <luke1027@p...>
wrote:

> Brady,
>
> I checked this link out ... wow, I find it confusing to
> decide what exactly I would need ... and what it will cost.
> Please when you decide what exactly what you are are ordering,
> will you please pass that info my way?
> From what I see it may cost over $60.00+ / drive.
>
> Luke
>
>
> braidmeister wrote:
>
> >http://www.usdigital.com/products/e3/
> >
> >E3 model with H option (thru hole for long tail shaft) and

probably

> >1000 CPR (counts per rev). Haven't figured out which one exactly

yet,

> >because I may opt to get connectors and cables as well when I

order.

> >I am also not sure what the limit is on the Geckos or Rutex as far

as

> >how many lines I can go max (is there a restriction?)
> >
> >-Brady
> >
> >
> >