Re: [CAD_CAM_EDM_DRO] Lead screws and mill dust

Hi Bill,

Oiled felt wipers work well. Gently clamp a piece of felt around the
screw close to the nut. Add a few drops of oil and the job is done. Felt
is very good at wiping dust off screws so virtually nothing will get to
the nut. It also leaves a trace of oil on the thread to keep the nut
lubricated.

Les

wdavis364 wrote:

> I'm posting this in serceral groups
> Looking for ideas here.
> What can I use to help keep lead screws free from mill shavings?
> My table is 14" by 8". I'll be milling mostly circuit boards.
> I bought 7 ½ in by 12 in bellows (rubber material, not was I expecting)
> and been trying to figure out to make them work with no luck. They sag
> to much.
> I planned to use vacuum near the point of the bit during milling and
> maybe I can get by without the bellows.
> Maybe some of you will tell me what works for you
> thanks
> bill
>