CAD CAM EDM DRO - Yahoo Group Archive

Re: port problem

Posted by Lee Studley
on 2000-10-14 16:09:25 UTC
Hi Alan and Terry,

Tim Goldstein's weblink at:
http://206.19.206.56/parallel.htm

Shows the connections at the bottom in a picture.
The goal is to not draw hardly any current from the
parallel port like you said(only several Ma max.)
You can up the voltage to the relay to a 12v or 15v
supply if the relay needs more volatge across the coil.
To be safe, use 2 1.5v batteries as the "control pin"
supply till you get it working, then connect it to the
parallel port after its verified. Use the values of
resistors in the diagram to limit currents to safe values
or you will damage the port for certain.

-Lee

Discussion Thread

Terry Ackland 2000-10-14 06:00:50 UTC port problem Art Fenerty 2000-10-14 10:50:32 UTC Re: [CAD_CAM_EDM_DRO] port problem Tim Goldstein 2000-10-14 11:14:54 UTC RE: [CAD_CAM_EDM_DRO] port problem Alan Marconett KM6VV 2000-10-14 12:19:37 UTC Re: [CAD_CAM_EDM_DRO] port problem Terry Ackland 2000-10-14 15:18:13 UTC Re: port problem Alan Marconett KM6VV 2000-10-14 16:00:56 UTC Re: port problem Lee Studley 2000-10-14 16:09:25 UTC Re: port problem Alan Marconett KM6VV 2000-10-14 16:43:23 UTC Re: port problem Alan Marconett KM6VV 2000-10-14 16:49:53 UTC Re: port problem ballendo@y... 2000-10-14 20:10:33 UTC Re: port problem Lee & Chris studley 2000-10-14 20:24:36 UTC Re: [CAD_CAM_EDM_DRO] Re: port problem Jon Elson 2000-10-14 23:00:35 UTC Re: [CAD_CAM_EDM_DRO] port problem ballendo@y... 2000-10-15 00:33:09 UTC re:Re: port problem John D. Bussema 2004-10-27 18:54:39 UTC port problem Andy Wander 2004-10-27 18:58:23 UTC RE: [CAD_CAM_EDM_DRO] port problem John D. Bussema 2004-10-27 19:30:23 UTC Re: [CAD_CAM_EDM_DRO] port problem wanliker@a... 2004-10-27 19:40:21 UTC Re: [CAD_CAM_EDM_DRO] port problem Brian 2004-10-27 19:45:31 UTC Re: [CAD_CAM_EDM_DRO] port problem caudlet 2004-10-27 22:38:32 UTC Re: port problem R Rogers 2004-10-28 07:09:28 UTC Re: [CAD_CAM_EDM_DRO] Re: port problem Jon Elson 2004-10-28 09:22:02 UTC Re: [CAD_CAM_EDM_DRO] Re: port problem Andy Wander 2004-10-28 10:20:11 UTC RE: [CAD_CAM_EDM_DRO] port problem