Re: port problem
Posted by
ballendo@y...
on 2000-10-14 20:10:33 UTC
Terry,
Alan gives you some good advice, but be sure your SSR can take 12V.
A lot of these are 3-32V, so ok, but some are TTL input so 12v=smoke!
Ballendo
Alan gives you some good advice, but be sure your SSR can take 12V.
A lot of these are 3-32V, so ok, but some are TTL input so 12v=smoke!
Ballendo
>No, I'm afraid that won't do. Connected this way, you are trying to
>source current to drive the SS relay. The '374 latch IC (or whatever
>part they're using) will only supply a few mills of current in this
>mode.<snip>Alan
Discussion Thread
Terry Ackland
2000-10-14 06:00:50 UTC
port problem
Art Fenerty
2000-10-14 10:50:32 UTC
Re: [CAD_CAM_EDM_DRO] port problem
Tim Goldstein
2000-10-14 11:14:54 UTC
RE: [CAD_CAM_EDM_DRO] port problem
Alan Marconett KM6VV
2000-10-14 12:19:37 UTC
Re: [CAD_CAM_EDM_DRO] port problem
Terry Ackland
2000-10-14 15:18:13 UTC
Re: port problem
Alan Marconett KM6VV
2000-10-14 16:00:56 UTC
Re: port problem
Lee Studley
2000-10-14 16:09:25 UTC
Re: port problem
Alan Marconett KM6VV
2000-10-14 16:43:23 UTC
Re: port problem
Alan Marconett KM6VV
2000-10-14 16:49:53 UTC
Re: port problem
ballendo@y...
2000-10-14 20:10:33 UTC
Re: port problem
Lee & Chris studley
2000-10-14 20:24:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: port problem
Jon Elson
2000-10-14 23:00:35 UTC
Re: [CAD_CAM_EDM_DRO] port problem
ballendo@y...
2000-10-15 00:33:09 UTC
re:Re: port problem
John D. Bussema
2004-10-27 18:54:39 UTC
port problem
Andy Wander
2004-10-27 18:58:23 UTC
RE: [CAD_CAM_EDM_DRO] port problem
John D. Bussema
2004-10-27 19:30:23 UTC
Re: [CAD_CAM_EDM_DRO] port problem
wanliker@a...
2004-10-27 19:40:21 UTC
Re: [CAD_CAM_EDM_DRO] port problem
Brian
2004-10-27 19:45:31 UTC
Re: [CAD_CAM_EDM_DRO] port problem
caudlet
2004-10-27 22:38:32 UTC
Re: port problem
R Rogers
2004-10-28 07:09:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: port problem
Jon Elson
2004-10-28 09:22:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: port problem
Andy Wander
2004-10-28 10:20:11 UTC
RE: [CAD_CAM_EDM_DRO] port problem