Re: Engraving and engine turning

>From: TADGUNINC@...
>
>I may be way off here of what you are trying to do but, couldn't keep the
>spindle stationary, and use a rotary table? You would only need to use one
>axis of the milling table, and coordinate it with the rotation of the rotary.
>Tracey

This might be a good start, but eventually I want to be able to do
different patterns, (or combine them) in one setup. For example, a square
dial with an arch top could have a rose engine pattern in the arch,
continuing into a straight line pattern in the square bottom half of the
dial.

David M. Munro