Re: Re: Engraving and engine turning

At 10:23 PM 29/07/99 -0500, you wrote:
I've been lurking and running Dancam on an old Toshiba 1200 -- about a 8086
or 80186 max and it works on my Unimat SL with Dan's controler circut. Feed
rates are fine, but I can't go more than 6" anyhow :)
Dancadd I do run on a faster machine though.

Jeff

>The program works on a DOS (not windows) machine, and this brings up the
>question of where I would best acquire something as obsolete as an Edison
>phonograph, while still being reliable enough and fast enough to power a
>mill. At what phase of PC evolution was DOS completely abandoned? I went
>straight from commedore vic 20 to my first of a series of mac's so I am
>completely ignorant about DOS.
>
>David M. Munro
>
>--------------------------- ONElist Sponsor ----------------------------
>
>Show your ONElist SPIRIT!
>http://www.onelist.com/store/tshirts.html
>With a new ONElist SHIRT available through our website.
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>
>
>
>