CAD CAM EDM DRO - Yahoo Group Archive

Re: re:Re: Re: Is this too nuts to consider ?

Posted by ballendo@y...

on 2001-01-25 21:44:57 UTC

Smoke wrote:
<snip>cut spiral grooves on the inner tube,<s>in far enough to engage
the slots.

Smoke,

It's these grooves, or slots, that Alan is trying to cut! (one TPI)

The bearings eliminate the need for the slot/groove, and that's the
point of my post.

Ballendo

Discussion Thread

beer@s... 2001-01-25 10:45:21 UTC Is this too nuts to consider ? Smoke 2001-01-25 11:05:21 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? Jon Elson 2001-01-25 11:27:50 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? Joe Vicars 2001-01-25 11:45:21 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? Joe Vicars 2001-01-25 12:00:44 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? Smoke 2001-01-25 12:46:12 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? beer@s... 2001-01-25 15:23:54 UTC Re: Re: Is this too nuts to consider ? Area51tats@a... 2001-01-25 15:45:23 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? Smoke 2001-01-25 16:09:10 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Is this too nuts to consider ? Alan Marconett KM6VV 2001-01-25 16:51:56 UTC Re: Is this too nuts to consider ? Jon Anderson 2001-01-25 17:41:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Is this too nuts to consider ? ballendo@y... 2001-01-25 18:28:20 UTC Re: Is this too nuts to consider ? Smoke 2001-01-25 19:07:13 UTC Re: [CAD_CAM_EDM_DRO] Re: Is this too nuts to consider ? ballendo@y... 2001-01-25 20:53:55 UTC re:Re: Re: Is this too nuts to consider ? JanRwl@A... 2001-01-25 20:59:22 UTC Re: [CAD_CAM_EDM_DRO] Is this too nuts to consider ? Smoke 2001-01-25 21:05:49 UTC Re: [CAD_CAM_EDM_DRO] re:Re: Re: Is this too nuts to consider ? Smoke 2001-01-25 21:15:45 UTC Re: [CAD_CAM_EDM_DRO] Re: Is this too nuts to consider ? ballendo@y... 2001-01-25 21:44:57 UTC Re: re:Re: Re: Is this too nuts to consider ? Smoke 2001-01-25 23:41:43 UTC Re: [CAD_CAM_EDM_DRO] Re: re:Re: Re: Is this too nuts to consider ? fastvid@e... 2001-01-26 09:15:24 UTC Re: Is this too nuts to consider ? Dick Ganderton 2001-01-26 13:58:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Is this too nuts to consider ?