Novamill

List,

I have a Novamill from Denford
http://www.denford.co.uk with the following
specifications:
Serial No. EO 5149
Year of manufacture: 1998
system resolution: 0.01mm or 0.0004in.
Stepper motors: 200 steps/rev
machine control software: MS-DOS file FANUCMD
with "qwerty" "keyboard" desktop tutor keypad input
(Fanuc simulated control panel?) connected to COM1
port
RS232 cable from COM2 port to Machine Control Box to
mill

Currently I am using Mill CAM Designer 2 from Denford
to generate G-codes for the Mill
but the software is far too limited to be really
useful.

QUESTION:
I wish to use other softwares to generate G-code for
the Novamill.
Are there anyone with prior experience with Novamill
and have some good CAM
software with suitable postprocessors to recommend for
use with this mill?

Thank you in advance.

Peter



__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/