Re: [CAD_CAM_EDM_DRO] Bridgeport Tracer?

I've been told this mill would be approximately 15,000 - 20,000$ new. Does
that sound right?

John

> > 5.)
> > Approximately, very approximately, hiw much would a mill
> > like this weigh? A few thousand lb's, tens of thousands or
> > simply concrete destroying lb's? The table would be about
> > stomach height from the pictures so I think it might just go
> > in the garage! `.^)
>
> As best I understand it automated Bridgeports came in Series I and Series

II

> version. A Series I is about 3,000 lbs. A Series II is closer to 6,000

lbs.

> A Series II is about 93 inches to the top of the motor and does fit into

my

> 2 car garage.
>
> Tim
> [Denver, CO]
>
> >
> > FAQ: http://www.ktmarketing.com/faq.html
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>