Re: [CAD_CAM_EDM_DRO] Motor Noise?

----- Original Message -----
From: "Rich D." <cmsteam@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, June 22, 2001 3:51 PM
Subject: Re: [CAD_CAM_EDM_DRO] Motor Noise?


> Phil,
> Radio Shack stores, Radio Shack.com and other computer stores carry them.
> Ham radio outlets also.
> RichD
>
> phil wrote:
> >
> > Alan,
> >
> > I was thinking about trying these but didn't know where to buy them. Any
> > ideas on suppliers of these ?
> >
> > thanks
> >
> > Phil
> > ----- Original Message -----
> > From: "Alan Marconett KM6VV" <KM6VV@...>
> > To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> > Sent: Thursday, June 21, 2001 11:03 PM
> > Subject: Re: [CAD_CAM_EDM_DRO] Motor Noise?
> >
> > > Hi Phil,
> > >
> > > You might try some of the "clamp-on" ferrite cores used for computer
> > > cables. At the speed control, at the computer parallel port cable, at
> > > the driver, etc.
> > >
> > > Alan KM6VV
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>