RE: [CAD_CAM_EDM_DRO] Re: Camtronics

hey tim? I (eventually) want to get a bridgeport and convert it to emc. is
that what software bridgett is running? I heard a rumor that there was a
limit with the step and direction pulses that emc could put out, so that
rapids aren't as 'rapid' as they should be, have you had any issues?
---thanks, Dave L.

-----Original Message-----
From: Tim [mailto:timg@...]
Sent: Thursday, November 15, 2001 8:36 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: RE: [CAD_CAM_EDM_DRO] Re: Camtronics


While talking about Camtronics I thought I would mention the heatsink
that Dan has to fit the Gecko drives. It is a big massive thing that is
drilled and tapped to hold 4 drives (G2XX or G3X0) and has additional
holes to allow mounting the heatsink to your cabinet. I got one and it
really solved a mounting issue I had. I am using it with a single 3 some
odd inch 110 v fan setting flat on the fins and blowing into the
heatsink. It is staying room temperature with no noticeable heat rise
even after running Bridgett for a few hours. Much easier to mount than
using CPU fans. It is also a very good value.

Tim
[Denver, CO]


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/